Empresa China de Herramientas de Precisión
Traducción
English中文(简体)FrançaisРусскийEspañol

cara de desmontaje en piezas torneadas: decide si es una superficie terminada

» blog » Part-Off Face on Turned Parts: decide si es una superficie terminada

cara de desmontaje en piezas torneadas: decide si es una superficie terminada

Noviembre 15, 2026

The face created when a turned component separates from the bar is easy to overlook in the quotation. If it later contacts a washer, seal or another assembly surface, its condition may matter more than a general note to remove burrs suggests.

Identify the function of the separated face

Mark whether the face is a clearance end, an assembly stop or a functional mating surface. Apply size, geometry or finish requirements only where they matter. Tell the supplier if a remaining center pip is unacceptable rather than assuming that it will be covered by an edge-break note.

Ask how the final condition will be achieved

For a functional face, have the supplier state whether the quoted route includes a finishing pass after separation or another way of meeting the released drawing. Ask the supplier to explain any allowance or holding requirement that affects price or part handling. Do not prescribe one cutting method unless the project requires it.

Check the sample after all operations

Evaluate the final face after any finishing and deburring. Include the edge where it meets the outside diameter and the center region if a residual projection matters. If a follow-on coating affects the fit, make clear which post-coating dimensions or surface conditions need verification.

What to include in the RFQ

  • Marked separated face and its assembly function
  • Limits for residual features, edge condition and face geometry where required
  • Acabado, coating and final inspection responsibilities

If the same face also carries a groove, show the groove diameter range separately from the face finish requirement.

For a broader look at turned faces and edge requirements, see our CNC turning capabilities.

Technical reference: Sandvik Coromant guidance on parting and grooving tool setup.

blog

Quizás también le guste