中国精密工具公司
翻译
English中文(简体)FrançaisРусскийEspañol

Insert Location and Cavity Joints

Mold Inserts for Aluminum Die Casting

Use the insert drawing and parent die section to define seating, retention and cavity-joint checks.

工艺
Review insert fit against the parent die assembly
材料
Specify the insert material and treatment separately from the casting alloy
数量
Identify the insert positions and any spare quantities required
检验
Define individual insert and assembled cavity-joint checks

产品概览

Consider an insert that forms part of a cavity for an aluminum casting. Use the insert drawing and the matching parent die section to identify the seating face, lateral locating features and retention method. Confirm the insert material, heat treatment and finish on the tooling drawing.

主要特征

  • Mark the surfaces that support and locate the insert and the surfaces that provide assembly clearance.
  • Identify any specified step, gap or profile limit where the insert meets the surrounding cavity.

制造注意事项

  • Confirm drawing revisions, fitting and removal access, and the delivery condition for dimensional checks.
  • Agree which checks apply to the individual insert and which require the parent die.

Quality Control & 检验

  • Check specified insert profile and mating dimensions from the agreed references. Record the drawing revision and inspection condition.
  • Where an assembled check is required, seat and retain the insert as specified. Verify the applicable step, gap or profile limits at the marked joint.

需确认的规格

图纸Insert drawing and matching parent die section
MaterialInsert grade, treatment and finish
Location and retentionSeating face, lateral locators and retention method
ClearanceFitting or removal access and clearance surfaces
Cavity jointApplicable step, gap or profile requirement
Inspection scopeReferences, results required and condition for each check

装配注意事项

Seat and retain

Verify seating, lateral location and retention against the parent die section.

Check the joint

Where required, inspect the marked joint in the specified assembly condition.

Submit an Insert Drawing for Review

Send the insert drawing and parent die section with the locating faces, retention features, cavity joint and assembled inspection requirements marked.