A face groove is cut axially into a turned face. Giving only its width and depth leaves open where the groove sits and which surfaces provide access. A section through the groove often answers more quotation questions than a general note on the view from above.
Identify the inner and outer groove boundaries, axial depth reference and corner geometry. Mark nearby shoulders or bosses that limit tool access. Sandvik's face-grooving guidance treats groove diameter and depth as inputs to tool selection, so these values should be available before the supplier commits to a process.
If the groove holds a seal or locates a mating part, identify the active walls and floor. Put finish requirements on the working surfaces rather than extending the tightest value to the entire turning. Define whether sharp internal corners are functional or whether a permitted radius can be quoted.
Agree how groove width, depth and location will be measured on the actual part and whether a sectioned sample is needed for a first article. If the buyer and supplier use different tools, agree how they will resolve a near-limit reading rather than comparing values from unlike setups.
If the grooved face is also the part-off face, specify whether it is a finished surface and state how it will be checked.
For related turned features, explore our CNC turning capabilities.
Technical reference: Sandvik Coromant face-grooving guidance.